
Probes
Prepare any of the ZENNIUM workstations for special fields of application like high impedances, low impedances, very low capacitance or boost the compliance voltage.
HiZ Probe
The HiZ probe set is specially designed for high impedance measurements and raise the input impedance up to 1000 TΩ || 1 pF.
LoZ Cable Set
The LoZ cable set is specially designed for low impedance measurements. The symmetric geometry of the cables reduce the influence of mutual induction as much as possible.
fF Probe
The femto-Farad Probe can measure very low capacitance with a resolution of 0.1 fF. Due to the transimpedance princible the fF Probe is designated for the application on two-pole objects.
CVB120
The Compliance Voltage Booster 120 provides a controlled voltage of up to ±100 V and a compliance voltage of up to ±120 V. The CVB120 is a booster which is to be connected to the Probe E/I connectors of a ZENNIUM Electrochemical Workstation.
FRA Probe
The FRA module interfaces third-party potentiostats and electronic loads to the IM6/Zennium system. The external device must provide an analog control input and analog signal outputs for the measured current and voltage.
Noise Probe
The Noise Probe is a low power potentiostat for all our electrochemical workstations, ZENNIUM X, ZENNIUM pro and ZENNIUM, and is specially designed for all common electrochemical noise techniques. In addition Zahner developed CorrElNoise®. This revolutionary new method is superior to common ECN techniques by avoiding most of their typical problems.